MINISTRY OF
NATURAL RESOURCES AND ENVIRONMENT
--------
|
SOCIALIST
REPUBLIC OF VIETNAM
Independence – Freedom – Happiness
----------------
|
No.:
07/2005/QD-BTNMT
|
Hanoi, 20
September 2005
|
DECISION
ON REQUIRED APPLICATION
OF VIETNAME STANDARD TCVN
7440:2005 – EMISSION STANDARDS FOR THERMAL POWER INDUSTRY
MINISTER OF NATURAL RESOURCES AND ENVIRONMENT
Pursuant to the Law on Environmental
Protection dated 27/12/1993;
Pursuant to the Decree No. 175/CP dated
18/10/1994 of the Government guiding the implementation of the Law on
Environmental Protection and the Decree No. 143/2004/ND-CP dated 12/7/2004 of
the Government on the amendment, addition of Article 14 of the Decree No. 175/CP
dated 18/10/1994 of the Government guiding the implementation of the Law on
environmental Protection;
Pursuant to the Decree No. 91/2002/ND-CP
dated 11/11/2002 of the Government regulating the functions, tasks, powers and
organizational structure of the Ministry of Natural Resources and Environment;
Pursuant to the Decision No. 1793/QD-BKHCN
dated 20/7/2005 of the Minister of Science and Technology on issuing the
Vietnam Standard TCVN 7440 :
2005 - Emission standards for thermal power industry;
Considering the recommendations of the
Director General of Department of Environment and the Director General of
Department of Legal Affairs,
...
...
...
Bạn phải
đăng nhập hoặc
đăng ký Thành Viên
TVPL Pro để sử dụng được đầy đủ các tiện ích gia tăng liên quan đến nội dung TCVN.
Mọi chi tiết xin liên hệ:
ĐT: (028) 3930 3279 DĐ: 0906 22 99 66
Article 1. To require the application of
the Vietnam Standard TCVN
7440:2005 - Emission standards for thermal power industry which has
been issued by the Minister of Science and Technology in the Decision No.
1793/QD-BKHCN dated 20/7/2005 under the following provisions:
- The thermal power plant projects which are
newly built, the expansion projects to raise the capacity of active thermal
power plants must apply the Vietnam Standard TCVN
7440:2005 from the effect of this Decision on required application.
- The active thermal power plants and the
thermal power plants whose reports on environmental impact assessment have been
approved before the effective date of this Decision on required application
must apply the Vietnam Standard TCVN 7440 :
2005 from 01/012015, except the plants named in the list of
facilities which cause serious environmental pollution and must be thoroughly
treated under the provisions of the Decision No. 64/2003/QD-TTg
dated 22/4/2003 of the Prime Minister.
Article 2. The regional and area
coefficient (Kv), power coefficient (Kp) and the method for calculation of
permissible maximum concentration of SO2, NOX and dust in
the emission of the thermal power plants using coal or oil fuel specified in
the Appendix 1 attached to this Decision.
Article 3. This Decision takes effect 15 days after its publication in the Official Gazette.
The Ministers and Heads of ministerial bodies,
Heads of governmental bodies, Chairman of People’s Committee of provinces and
centrally-run cities, organizations and individuals are liable to execute this
Decision./.
MINISTER
Mai Ai Truc
...
...
...
Bạn phải
đăng nhập hoặc
đăng ký Thành Viên
TVPL Pro để sử dụng được đầy đủ các tiện ích gia tăng liên quan đến nội dung TCVN.
Mọi chi tiết xin liên hệ:
ĐT: (028) 3930 3279 DĐ: 0906 22 99 66
APPENDIX 1
DETERMINING THE
POWER COEFFICIENT (Kp), REGIONAL AND AREA COEFFICIENT (Kv), AND THE METHOD FOR
CALCULATION OF PERMISSIBLE MAXIMUM CONCENTRATION OF SO2, NOX
AND DUST IN THE EMISSION OF THE THERMAL POWER PLANTS USING COAL OR OIL FUEL TO
APPLY THE VIETNAM STANDARD TCVN 7440 :
2005
(Issued with the Decision No. 07/2005/QD-BTNMT dated 20/9/2005 of the
Minister of Natural Resources and Environment)
1. Formula to calculate the maximum
permissible concentration
The maximum permissible concentration of
pollutants (SO2, NOX and dust) of the emission in thermal
power plants using coal or oil fuel discharged into the air is calculated as
follows:
Cmax
= Ctc x Kp x Kv
In which:
Cmax is the maximum
permissible concentration of pollutants of the emission in thermal power plants
using coal or oil fuel discharged into the air and is measured in milligram per
cubic meter of emission at standard conditions (mg / Nm3);
Ctc is the maximum permissible
concentration of pollutants specified in the Vietnam Standard TCVN
7440:2005;
Kp is the power coefficient of
thermal power plants (the coefficient depends on the scale of waste source).
...
...
...
Bạn phải
đăng nhập hoặc
đăng ký Thành Viên
TVPL Pro để sử dụng được đầy đủ các tiện ích gia tăng liên quan đến nội dung TCVN.
Mọi chi tiết xin liên hệ:
ĐT: (028) 3930 3279 DĐ: 0906 22 99 66
2. Value of Kp coefficient
The value of Kp coefficient is specified in
Table 1 below.
Table 1: The
value of Kp coefficient corresponding to capacity of thermal power plants
Capacity of
thermal power plants
Kp
coefficient
P ≤ 300 MW
Kp =
1
300 MW < P ≤
600MW
Kp =
0.85
...
...
...
Bạn phải
đăng nhập hoặc
đăng ký Thành Viên
TVPL Pro để sử dụng được đầy đủ các tiện ích gia tăng liên quan đến nội dung TCVN.
Mọi chi tiết xin liên hệ:
ĐT: (028) 3930 3279 DĐ: 0906 22 99 66
Kp =
0.7
P is the total capacity of the thermal power plants
which are newly built, including one generating unit or a lot of generating
units. For the expansion projects to raise the raise the capacity of active
thermal power plants, P is the total capacity of new generating units (total
expansion capacity of plants).
3. Value of Kv coefficient
The value of Kv coefficient is specified in
Table 2 below.
Table 2: The
value of Kv coefficient is corresponding to the building regions and areas of
power thermal plants
Region
classification
Kv
coefficient
Region 1
Special urban area (1), Type I
urban area (1), ecologically sensitive area (2)
...
...
...
Bạn phải
đăng nhập hoặc
đăng ký Thành Viên
TVPL Pro để sử dụng được đầy đủ các tiện ích gia tăng liên quan đến nội dung TCVN.
Mọi chi tiết xin liên hệ:
ĐT: (028) 3930 3279 DĐ: 0906 22 99 66
Region 2
Type II, III, IV urban areas (1)
0.8
Region 3
Industrial parks
1.0
Region 4
Rural and mountainous delta and Type V urban
area V (3)
1.2
...
...
...
Bạn phải
đăng nhập hoặc
đăng ký Thành Viên
TVPL Pro để sử dụng được đầy đủ các tiện ích gia tăng liên quan đến nội dung TCVN.
Mọi chi tiết xin liên hệ:
ĐT: (028) 3930 3279 DĐ: 0906 22 99 66
(1) The urban areas determined under the
provisions in the Decree No. 72/2001/ND-CP dated 5/10/2001 of the Government.
(2) The ecologically sensitive areas are the national
parks, conservation areas, biosphere reserves, conservation areas of breeds and
species, conservation areas of landscape,
cultural
and historical monuments that are established under the decision of the Prime
Minister or the line ministries.
(3) Where the thermal power plants are located
in region 4 but the distance between the thermal power plants and the boundary
of regions 1, 2 and 3 is smaller or equal to 5 km, the Kv area coefficient
corresponding to the regions 1, 2 and 3 (Kv is 0.6, 0.8 and 1 respectively)
shall apply.